Buy ASTM D CLASSIFICATION FOR MACHINE-MADE ‘ FIBERGLASS’ (GLASS-FIBER-REINFORCED THERMOSETTING-RESIN) PIPE from SAI. Find the most up-to-date version of ASTM D at Engineering This classification covers machine-made “fiberglass” (glass-fiber-reinforced thermosetting-resin) pressure pipe. Methods of classification.
|Country:||Antigua & Barbuda|
|Published (Last):||24 September 2010|
|PDF File Size:||20.21 Mb|
|ePub File Size:||12.50 Mb|
|Price:||Free* [*Free Regsitration Required]|
Table 1 data was divided into 4 Parts for spacing considerations.
This standard has been approved for use by agencies of the Department of Defense. Note 1 — For the purposes of this standard, polymer does not include natural polymers.
The values in parentheses are provided for information only.
It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. This standard is subject to revision at any time by the responsible technical committee and must be reviewed every? The script was ‘debugged’ to the best of our ability! The American Society for Testing and Materials takes no position respecting the validity of any patent rights asserted in connection with any item mentioned in this standard.
It is not based on dimensions or raw material speci? A The cell-type format provides the means of identification and specification of piping materials.
B Refer to Practice D to obtain classification of d23100 values. Methods of classification, requirements, test methods and the method of marking are included.
A hydrostatic design basis as shown in Table 1 shall be determined for each type, grade, and class of product manufactured. Your comments are invited either for revision of this standard or for additional standards and should be addressed to ASTM Headquarters.
Each part is one ‘designation order’ i. NOTE 5—Information regarding selection of service design factors and pressure rating is provided in Practice D and the individual product standards. The values in parentheses are provided for information only.
Therefore, it is possible to look up and ‘generate’ the ASTM D designation code or look up the property ‘by hand’. If you feel that your comments have not received a fair hearing you should make your views known to the ASTM Committee on Standards, at the address shown below.
Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard. For the second generator, the property must be supplied by the FRP fiberglass pipe manufacturer in order to generate the ASTM D designation code for the piping.
This standard is being withdrawn without replacement due to its limited use by industry. Two methods of classifying long-term strength are included: Current edition approved June 10, Individual reprints single or multiple copies of this standard may be obtained by contacting ASTM at the above address or at phonefaxor service astm. Link to Active This link will always route to the current Active version of the standard. NOTE 1—For the purposes of this standard, polymer does not include natural polymers.
Changes in materials or manufacturing processes will necessitate a screening evaluation as described in Practice D NOTE 3—All possible pressure strength combinations of types, grades, and classes may not be commercially available. The manufacturer should be consulted.
The inside diameter of d22310 Benton, Ar Cell: The manufacturer should be consulted. Note 2 — There is no known ISO equivalent to this standard.
This cell-type format, however, is subject to misapplication since unobtainable property combinations can be selected if the user is not familiar with commercially available products. This cell-type format, however, is subject to misapplication since unobtainable property combinations can be selected if the d23100 is asm familiar with commercially available products.
This standard does not purport to address all of the safety concerns, if any, associated with its use. The outside diameter of the? It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Stay e2310 Page Continue to Compass. Formerly under the jurisdiction of Committee D20 on Plastics, this standard was withdrawn in August B Refer to Practice D to obtain classi?