ASTM E1646 PDF

ASTM International E Standard Test Method for Water Penetration of Exterior Metal Roof Panel Systems by Uniform Static Air Pressure Difference. ASTM E(). Standard Test Method for Water Penetration of Exterior Metal Roof Panel Systems by Uniform Static Air Pressure. ASTM E is the standard test method for water penetration of exterior metal roof panels by uniform static air pressure difference. The ASTM E test.

Author: Mezigal Nataxe
Country: Maldives
Language: English (Spanish)
Genre: Science
Published (Last): 13 April 2007
Pages: 286
PDF File Size: 9.68 Mb
ePub File Size: 17.6 Mb
ISBN: 328-5-92927-998-8
Downloads: 3386
Price: Free* [*Free Regsitration Required]
Uploader: Mebar

Link to Active This link will always route to the current Active version of the standard. The preload test pressure differences positive and negative are to be specified.

A roof contains many details. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

These factors shall be fully considered prior to specifying the test pressure difference.

It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Read more about what our customers have to say In applying the results of tests by this method, note that the performance of a roof or its components, or both, may be a function of proper installation and adjustment.

These notes and footnotes shall not be considered as requirements of the test method. Referenced Documents purchase asym The documents listed below are referenced within the subject standard but are not provided as part of the standard. Then the specimen is preloaded with a negative static air pressure differential for a minimum of 10 seconds.

  LIBRO HOLOCAUSTO GERALD GREEN PDF

ASTM E – Farabaugh Engineering and Testing

This test method is a specialized adaption of Test Method E The slope of the roof is significant. Some designs are more sensitive than others to this upward moving water.

It does not include leakage at openings or perimeter or any other details. This process is repeated for a total of three cycles. A section of calibrated spray racks are set in place 12 inches above the specimen. For that reason the slope of the roof plays a significant importance.

ASTM E1646

This test method shall not, by itself, be relied upon to form conclusions about overall water asgm through metal roofs. The purpose of this test method is to conduct quality assurance water penetration testing of the roof including panel side laps and structural connections. SITC has utilized this test method to assist our clients with their quality assurance testing of metal panel roof systems. In service, the performance also depends on the rigidity of supporting construction, roof slope, and on the resistance of components to deterioration by various causes: This is a test procedure.

Although prescribed modifications are outside the scope of this test method, an experienced testing engineer is able to use the principles presented in this test method and generate significant data by isolating specific details and measuring leakage. For specific e16646 statements, see 7. Composite systems in which asym source cannot be readily determined are outside the scope of this test method. Practical considerations suggest that every combination of panel satm, span, and design load need not be tested in order to substantiate product performance.

  CARDURAN XL BULA PDF

Pre-loading is a essential part of the testing procedure. The calibrated spray racks shall deliver water uniformly against the roof surface at a minimum rate of five gallons per square foot per hour. After applying the preload there is a two s1646 recovery period. The test is conducted by attaching the chamber to the test specimen.

It is difficult to simulate the identical complex wetting conditions that can be encountered in service, including large wind-blown water drops, increasing water drop impact pressures with increasing wind velocity, and lateral or upward moving air and water. The positive test pressure shall be greater than or equal to 15 pounds per square foot.

Historical Version s – view previous versions of standard.

Prior to testing a positive static air pressure differential preload is applied.